Pedestrian gates

Serving customers Worldwide

All of our pedestrian gates are fabricated to either match one of our driveway gate designs, or as a unique/individual design. Pedestrian gates are fabricated (dependant on their design) using 40mm square hollow section for the frame work,
with 16mm diameter solid round bar for the uprights, 40mm x 10mm solid flat bar for horizonal rails and 20mm x 6mm solid flat bar for both circle and scroll details. If the pedestrian gate is to be infilled with composite or timber boards, or to be of a
traditional or contemporary design, the fabrication of these gates is to match that of the main driveway gate design.
Moneygaff Metalwork takes care to adjust the upright spacing so that the exact number of whole gaps between the vertical bars is achieved, at a nominal 100mm width.
Note: Other spacing of the rails other than 100mm can be produced, but our standard spacing is based on building regulations for the guarding of stairs. Document K1 1998 paragraphs 1.28 “along side drops greater than 600mm” and
“should prevent children being held fast by the guarding (i.e. getting their heads stuck between the rails).

All welding is to be done on the underside of the rails where possible, to ensure an aesthetic appearance.As standard, all gates will be fitted with a latch lock. The back/inside face of the gatewill be fitted with lugs, which will be fabricated to facilitate a padlock, if required.Other locks/latches can be fitted, however these maybe at an additional cost.
Please contact us, for further information regarding these alternatives